1. Locate the IAT (Intake Air Temperature) sensor in the intake. 2. Cut its signal wire and contact° the purple wires to the two ends. Direction does not matter. 3. Find the oxygen sensor(s) in the exhaust.°° 4. Broach the sensor's signal wire according to the following wiring table and contact there the blue cables. 5. Contact the red cable of doubled wire to the ignition battery + 12V, and the black thread to the ground or battery negative.
° For contact you might use the supplied terminals or solder the wires in place. °° By bikes without O2 sensor, do not use blue wires.
Mit diesem Beitrag wurden folgende Inhalte verknüpft